You may occasionally wish to disassemble your 9Barista machine to either replace or upgrade a component. We’ll show you how to do that here.
- 3mm Hex key
- 13mm spanner/wrench (only if you need to remove the Safety valve or Boiler pipe)
- T10 Torx screw driver (only if you need to remove the Chimney)
Remove the portafilter and unscrew the boiler until you feel the boiler o-ring disengage. There will be about a 3mm gap between the top of the boiler and the bottom of the grouphead.
Unscrew the three grouphead screws using the 3mm Hex key. The orange part, which is the group insulator, will spring up once the last screw is removed, so take care to gently hold it in place so you don’t lose any parts.
You will now be able to remove the group insulator, the grouphead o-ring and the valve chamber seal.
Lift the grouphead off, and take out the valve pin and the valve spring.
Finally, twist the heat exchanger coil anti-clockwise to remove it from the boiler. From this point replacing any individual component should be straight forward.
Perform the following maintenance checks:
- Check for any signs of damage to any of the o-rings, and replace if necessary.
- Gently clean and rinse the valve pin, making sure there is no scale or grit on either the valve pin or the spring. Next, check that the valve chamber is also clean.
- Check for a blockage in the heat exchanger coil by blowing into the boiler pipe. You should be able to blow a small amount of air through. If you can, there’s not a blockage.
- If you can’t blow through the boiler pipe, unscrew it and hold it up to the light to see if there’s any debris blocking the end. If there is, use a pin to dislodge and remove it, before screwing back into place. Tightening it with your fingers should be sufficient; turn until you feel resistance against the thermal break (the circular piece of black silicone rubber).
- Again, try to blow through the heat exchanger coil. If you can’t, and you know the boiler pipe is not blocked, it means that there’s a blockage in your heat exchanger coil. If this is the case please get in touch and we’ll help you further.
Reassemble the machine by following the steps 1 to 4 in reverse order.
When you come to fit the group insulator, be careful that the valve chamber seal locates correctly. To do this, position the valve chamber seal around the tip of the group insulator, and then press the these two parts on to the grouphead. If the group insulator is pushed up by the spring before you attach one of the three screws, the valve chamber seal may have dislodged.